A16 Pro Lightweight UAV Camera Module – 6 g, OEM Customization
A16 Pro Lightweight Camera Module
Compact camera module offered for UAV and embedded imaging integration, with supplier-supported customization.
- Model: A16 Pro
- Supplier-stated weight: approximately 6 g
- Supplier-stated maximum resolution: 1920 × 1080
- Fixed-focus design; custom cable configurations available on request
- Supplier advertises low-light capability and up to 120 fps; supported resolution and output mode require confirmation
Critical compatibility note: The source listing does not clearly establish CVBS, AHD, USB or other video output for the standard unit. Do not assume compatibility with analog FPV VTX equipment until the exact output protocol, supply voltage and connector pinout are confirmed.
What you still need
- A VTX with a compatible video standard
- 5V or variable supply within the camera's range
- A mount matching the camera width
Frequently Asked Questions
What information is needed to confirm a custom part?
Provide a dimensioned drawing or CAD file, material requirements, thickness or tube dimensions, hole locations, tolerances, finish and quantity. Confirm the final specification before ordering.
Are the photographed dimensions the final production dimensions?
Use the agreed drawing and the selected specification, not proportions measured from a photograph. Confirm critical clearances and hole spacing before production.
Does weave or appearance establish structural performance?
No. Appearance alone does not establish laminate construction, load capacity or suitability for a particular aircraft. Confirm engineering requirements for the intended application.
Are hardware and electronics included?
Only items explicitly listed for the selected configuration or agreed quotation should be treated as included. Confirm fasteners, inserts and any assembly work separately.
Can this part be installed without checking fit?
Compare the final dimensions and mounting interfaces with the intended assembly. Electrically isolate carbon-fiber parts from exposed conductors and inspect machined edges before installation.