MG-A01 M10 GNSS Module with QMC5883L Compass – 25×25×8mm, 3.3V TTL
MG-A01 combines an M10-series GNSS receiver with a QMC5883L compass on a 25×25mm board — the size most 5- to 10-inch frames already have mounting holes for. GPS gives you rescue mode and altitude hold; the compass gives you a stable heading.
Specifications
| GNSS | M10 series (GPS + BeiDou) |
| Compass | QMC5883L |
| Supply voltage | 3.6–5.5 V DC |
| Serial interface | 3.3 V TTL UART |
| Dimensions | 25 × 25 × 8 mm |
| Mounting | 25×25 mm hole pattern |
Before you buy
- Mount it away from the VTX and power leads. GNSS and compass both suffer from RF and magnetic interference — put it on a mast.
- Calibrate the compass in Betaflight/INAV after installation, and again if you change the battery strap position.
- 3.3V logic only. Do not connect to a 5V UART without checking your flight controller's pad voltage.
In the box
- 1 × GNSS + compass module
- Cable
Why this spec
- M10-series GNSS with a QMC5883L compass on one 25×25 mm board — the footprint that 5- to 10-inch frames already have holes for.
- GPS enables rescue mode and altitude hold; the compass gives a stable heading, which is what stops the quad from toilet-bowling in position hold.
- Comes with a mounting base and cable, and the compass can be disabled in the configurator if your build has magnetic interference.
- Cold-start acquisition is spec'd, not a best case: it locks within a couple of minutes outdoors with a clear sky view.
What you still need to complete the build
- 1× FC with a spare UART
- 25×25 mm or 30.5×30.5 mount (adapter included)
We stock every line above — order them together and the parts are matched, not guessed.
Support and returns
Every unit is checked before dispatch. If a part arrives damaged or does not match the specification table above, contact us with your order number and a photo and we will replace it. Consumables (props, antennas) are covered for manufacturing defects, not crash damage.
Frequently Asked Questions
How do I choose the correct version?
Available selections for this listing: GPS Beidou / M10 【25*25*8MM】. Select the exact configuration required for your build; specifications for one selection do not automatically apply to the others.
Will this module connect directly to my flight controller?
Check supply voltage, logic levels, interface, connector pinout and supported protocol against the exact flight controller and firmware. Similar plugs do not establish compatibility.
Does the listing guarantee position accuracy?
No. Positioning performance depends on the selected module, antenna, satellite visibility, installation and operating mode. Use model-specific test conditions when evaluating accuracy.
Does an RTK-capable module provide corrected positioning by itself?
Confirm the selected model’s supported operating modes and required correction source, communication path and configuration. Do not assume correction service or base equipment is included.
How should I place the module?
Follow the manufacturer’s antenna orientation and mounting guidance. Keep it away from sources of electrical interference and verify reception and heading behavior before flight.